Understanding the flock and the flocking process. I did this more as a test and for durability i have been rubbing it pretty vigorously to try to get it to rub off and it sticks pretty well . The more you apply, the better the results will be. The application is both durable and permanent. A metal screen is mounted halfway inside the canister opening. Before flocking the entire top of the dashboard, we tested the process on this this smaller area to see if there would be a reaction between the adhesive and the vinyl coating.
The paper you write on. They recommended their Wax and Grease Remover, Adhesion Promoter, and Vinyl and Fabric coating to safely accomplish the color change we wanted.Here's where we admit to a mistake and offer it as a warning for you to avoid. It's a simple, do-it-yourself process that yields a custom touch, but it is also functional. Be very generous when applying the fibers as the glue can soak through them. Our dashboard has the code "PC" molded into the manufacturing pad on the back. Flocking is the process of depositing many small fiber particles (called flock) onto a surface.It can also refer to the texture produced by the process, or to any material used primarily for its flocked surface. The process is pretty basic.Several different types of plastics are used by the automotive industry, and certain chemicals and coatings might not be compatible with them. Like share subscribe 100$ giveaway at 250 subs. Flock It's fiber applicator looks like a big salt shaker, but it's actually a tube that fits inside a bigger tube, and you pump the fibers out like you're pumping an old-fashioned bug sprayer. The damage is visible in this picture and looks like the cracks that form in a dry lake bed. Flocking fibres are very sensitive to humidity and temperature conditions. The electrostatic charge propels the fibres toward the grounded metal plate. Assuming your dashboard is out of the car, the process is cheap and easy to do. When it comes to getting the interior and your dashboard of your time attack project up to scratch, there are only a couple of options to have it looking professional. A small variation in temperature or a change in the percentage of relative humidity can result in a 3 to 4 factor change in the conductivity or electrical sensitivity of the flock and the substrate. It also looks very awesome when done well, so this process one of the things we get a lot of questions about. There are two types of flock - milled and cut. Proper application of the adhesive is the most important part of the process. You could apply real suede or Alcantara (the brand name of a synthetic microfiber material) upholstery to the dashboard, but that may be beyond the skills of the average enthusiast. The process uses special equipment that electrically charges the flock particles causing them to stand-up. The vibration promotes the density of fibres, which is critical to good fibre coating, and causes the flocking fibres to adhere to the adhesive and pack into a layer. Ebay is also a good source for kits to flock your dashboard. “Flocking” is a process of gluing tiny fibers to the top of the dashboard, which drastically reduces it’s ability to reflect the sun back onto the glass. There wasn't.As mentioned already, the flocking process itself is very simple, and our kit from Flock It came with everything we needed: the adhesive, a 1-pound bag of flocking fibers, and a flocking fiber applicator. The lesson: Following the Wax and Grease Remover (which was a mild solvent that did not damage the plastic), we applied three coats of the Adhesion Promoter. Something bigger like a 2.0 tip would have been better. It removed the stock coating and caused some slight cracks to form in the surface of the plastic, even though the package said it was safe for use on plastics.